14
2011
Foscam Clone Recovery (Teil 2)
Tweet To follow up on my previous post, the news is that I have successfully dumped all firmware parts of my camera. The bad news is that it didn’t work on my camera. The problem is this: audio_dev.state not AU_STATE_RECORDING wb_audio_start_record inet_sr.c INET_rinput 321 action===1 options==33 inet_sr.c INET_setroute 75 *args===255.255.255.255 *args===netmask *args===eth0 [29] write i2c error write i2c error write i2c error write i2c error write i2c error write i2c error write i2c error write [...]
8
2011
Foscam Clone Recovery Tool
Tweet I recently bought a few of these camera’s: http://www.chinavasion.com/product_info.php/pName/ip-surveillance-camera-with-angle-control-and-motion-detection/ There not very good, aber für so viel Geld was können wir erwarten! Nach der Installation die Cams und spielen ein bisschen mit ihnen kam der natürliche Drang, auf einem Gerät die neueste Firmware-flash-über mich. Ich schaute auf die Seite des China Vasion, aber nicht alles von einer neuen Firmware finden konnte. A bit disappointed I search on google and found out [...]
26
2010
One Click Firmware Updater for Netduino’s
Tweet I have created a one click firmware updater for the Netduino! The tool was initially build by forum user Randoom for the FEZ Devices. I took that code as my base and created the Netduino One Click installer. It detects a Netduino automatically and reads the currently installed firmware version, after that the tool will check on a remote site if there is a newer version of the firmware available (currently it is my [...]
1
2010
FEZ Domino DIY Projekt
Tweet I decided to take the ultimate challenge, at least for me, and that is that I am going to build a FEZ Domino from scratch, well not exactly from scratch, but anyway. I downloaded the schematics and PCB layout from the TinyCLR.com website. Next I went to my favorite PCB house Seeed Studio and ordered 10 PCB’s. I placed my order at the 14th of September, the boards where ready and shipped the 19th. [...]
30
2010
FEZ .NET Micro Framework Boards
Tweet In my last post I talked about a opensource .NET Micro Framework development platform, in the Arduino form factor, the Netduino. The Netduino is not the only .NET Micro Framework development platform there are many, many more. But few are as affordable as the Netduino. On board that is also relatively cheap are the FEZ Panda and FEZ Domino boards. Both boards are in the Arduino form factor. Where the Netduino is based on [...]
28
2010
Die Netduino
Tweet If you are into electronics and you are a .NET developer then this thing called the Netduino is something you might find interesting. The Netduino is in the same form factor as it’s smaller (CPU wise) brother the Arduino Above is the new Arduino Uno Today I received my Netduino package! A nice blue box. Inside is the Netduino board. Ofcourse I couldn’t wait and had already installed the necessary software on my development [...]
Blogroll
den letzten Kommentare
- Ramon van Bruggen auf Using Lync 2010 client in Office Communications Server 2007 R2 environment
- SImon auf Using Lync 2010 client in Office Communications Server 2007 R2 environment
- Giuseppe auf Foscam Clone Recovery (Teil 2)
- Merald auf Foscam Clone Recovery Tool
- Enricosoft auf Foscam Clone Recovery (Teil 2)

Ein Artikel von



